Electrical work in Lower Merion Township runs the full range, from a single outlet that stopped working to a whole-home rewire on a property that has carried the same wiring since it was built. The homes here are often older, and the systems inside them reflect that. A property that looks fine on the surface can have a panel that was never sized for what the house draws today, branch wiring that needs remediation, or circuits that have been patched and extended over decades without a clear record of what goes where.
We handle all of it. Straightforward repairs, panel upgrades, dedicated circuits, EV charger installations, backup generator hookups, safety inspections, and rewiring from the service entrance in. We take calls seven days a week, from 5:30 AM to 11:00 PM, and the price is confirmed before any work is scheduled.
Call (484) 266-5495 and we go from there.
A panel that was sized for a mid-century household was not designed with a Level 2 EV charger, a home office, or a finished lower level in mind. When a property needs more than its current electrical service can deliver, the answer is not always a full replacement. Sometimes a load calculation confirms there is room for one more circuit. Sometimes it confirms there is not, and the panel needs to come out before anything else goes in.
We start by looking at what the panel is actually carrying. That means checking the service entrance, counting the active circuits, and running a load calculation against what the property needs to support. If the panel has capacity, we pull the circuit. If it does not, we walk through the options: a service upgrade, a subpanel, or a combination of both depending on where the demand is concentrated.
A 100-amp service that has been carrying the same load for forty years may handle it fine until the day it does not. Adding a high-draw appliance, a charger, or a finished space tips the balance. In those cases, a 200-amp service upgrade gives the property room to grow without running every circuit near its limit.
Where the demand is concentrated in one area, a subpanel is often the cleaner solution. A workshop, a detached garage, or a finished basement with its own set of circuits does not need to share headroom with the rest of the house. We size the subpanel for what that space actually needs and run it from the main panel with a dedicated feed. Code-compliant wiring on every job, from the service entrance to the last breaker in the subpanel.
Electrical pricing follows the job, and the job is not fully visible until we have looked at it. What the fault turns out to be, what has to be opened up to reach it, and whether the existing panel or circuit can carry the change are the things that move the number. A repair that looks like a bad outlet sometimes turns out to be a wiring fault two circuits back. A straightforward panel swap sometimes uncovers a service-entrance issue that has to be addressed at the same time.
We give you the rate on the phone before anything is scheduled. The scope is agreed before the work begins, and any change to that scope gets discussed before it happens. Ask what the quote covers and you get a straight answer. There are no adjustments added after the fact without a conversation first.
We do not charge for estimates on work we are not going to do, and we do not recommend a panel replacement when a targeted repair is the right call. Honest recommendations on repairs, never an upsell, means the scope reflects what the property actually needs.
We are available every day from 5:30 AM to 11:00 PM, including weekends. For work that cannot be deferred, we take short-notice calls and do our best to get to it quickly. A burning smell near a panel, a breaker that will not reset, or a live wire that has come loose is not something to schedule for next week.
For rental properties and commercial spaces that have to stay occupied and open, we coordinate access on the scheduling call. If a tenant needs to be present, or if the work has to happen around business hours, we talk through what the job requires and confirm the timing before anything is booked. The scope and the price are settled on the call so there are no gaps in communication when the work starts.
Give us a call and consider it handled.
An outlet that has never worked since you moved in. A switch that sparks when you flip it. An exterior light that stopped coming on and has been off for two seasons. These are the jobs that land at the bottom of the list because they feel minor, and they stay there until something more urgent comes up.
The problem with deferring them is that a sparking switch is not a stable situation. A dead outlet can mean a tripped GFCI upstream, or it can mean a loose connection that has been arcing inside the wall. An exterior light that stopped working may have a straightforward fix, or it may have a wiring fault that gets worse in wet weather. None of these take long to diagnose. Getting them on the schedule is the step that keeps a small problem from becoming a larger one.
This is a local operation, and every customer matters. One call and we are on it.
A new electric range or wall oven almost always needs a dedicated circuit. Older kitchens were wired for gas appliances or for lower-draw electric models, and the existing wiring often does not match what a current appliance requires. The same applies to dryers. We check what is already there, confirm the panel has capacity, and run a properly sized circuit to the appliance location. If the panel needs room first, we handle that before the circuit goes in.
A detached garage or workshop that needs real power, not just a single outlet fed from the house, is a subpanel job. We run a dedicated feed from the main panel, install a subpanel sized for the load, and wire the circuits the space needs. For properties with multiple outbuildings or a garage that doubles as a workspace, this is the approach that gives each space its own capacity without pulling from the main panel every time something draws hard.
Exterior lighting covers a wide range of work, from replacing a single porch fixture to wiring a full landscape lighting layout or adding motion-sensor security lights at entry points and along the perimeter. We run weatherproof circuits, use fittings rated for outdoor exposure, and confirm the wiring is protected against the conditions it will face through the region's winters. Security lighting tied to motion sensors or a photocell is wired to operate independently from interior circuits.
A ceiling fan installation is straightforward when the right wiring is already in place. When it is not, the job involves running a switch leg, installing a fan-rated box, and sometimes pulling a new circuit depending on what the existing wiring can support. We handle the assessment and the installation together. For replacements, we check that the existing box is rated for a fan before anything goes up.
We serve Lower Merion Township and the surrounding areas throughout Montgomery County and beyond. If you are in the area, we can get to you.
Whether the call comes from a single-family home in Lower Merion Township or a property in one of the surrounding communities, the process is the same. We scope the job on the call, confirm the price, and schedule the work. We keep your home powered and safe. For what the job actually entails, the page listing our electrical services lays it out.
It depends on the extent of the work and which parts of the property are affected at any given time. For a full rewire, some disruption to daily use is unavoidable, but we work through the property in sections where possible. We discuss the realistic impact on the household during the scoping call so you can plan accordingly.
Yes, and it often makes sense to do that. If you have a list of outlets to replace, a ceiling fan to hang, and a switch that has been acting up, we can work through all of it in a single appointment. Tell us what you have on the list when you call and we will scope the time needed.
We leave the work area clean and the circuits we worked on tested and confirmed functional. Any materials we removed are taken with us. If the job involved opening a wall or ceiling, the electrical work is complete but any surface patching is left for the appropriate trade.
We work with homeowners managing older properties, landlords keeping rental units up to code, and property managers coordinating repairs or upgrades across multiple units. The work ranges from a single repair to a full rewire, and we approach each job the same way regardless of the scope.
We can walk you through what we found and what the options are, including what happens if you defer the work and what the risks of doing so are. The decision to proceed is always yours. We give you the information you need to make it.
Yes. We assess what has been done, confirm it is safe and correct, and complete the remaining work. If any of the existing work does not meet code, we explain what needs to be corrected before we continue. We scope what we find on the visit and confirm the price before proceeding.
Yes. When you call, we talk through what you are dealing with, what the likely scope is, and what the work involves. That conversation is part of how we scope the job and confirm the price. You are not committed to anything until you decide to schedule.
The price is agreed on the phone before anything is scheduled. That is how every job here works, whether it is a single outlet or a full-panel replacement. Schedule it. We wire it. You're powered.
Call (484) 266-5495. We are available every day from 5:30 AM to 11:00 PM.
Everywhere else we go is in our full service area. Electrical service reaches these neighboring areas too: Haverford Township, Radnor Township, Upper Darby Township.
From a dead outlet to a full service upgrade, we handle the electrical work that keeps Lower Merion Township homes and businesses running. The table below covers what each service includes, who it fits best, and what is worth knowing before you call. If a job is not listed or you are not sure what you need, a quick call gets you a straight answer and a price before anything is scheduled.
| Service | Scope of Work | When You Need It | What to Keep in Mind |
|---|---|---|---|
| Electrical Panel & Service Upgrades |
| Homeowners adding an EV charger, finishing a basement, or running a new high-draw appliance | Older Montgomery County homes on 100-amp service often hit their limit before the first EV charger or major addition goes in. We scope what the panel needs on the call. |
| Breaker & Fuse Repair |
| Homes with a breaker that fails repeatedly or a fuse box that is no longer practical | A breaker that trips under ordinary load is telling you something. We find the cause before swapping hardware. |
| EV Charger Installation |
| EV owners whose current panel may not have room for a Level 2 charger circuit | We run a load calculation before pulling the circuit. If the panel is near its limit, we talk through upgrade options before anything is installed. |
Not sure which service fits your situation, or want to know what a job will run before you commit? Call (484) 266-5495 and we will walk through it with you.
(484) 266-5495